Loosen all four preassembled mounting bracket screws (S), then completely remove the two mounting bracket screws (S) from the round holes of canopy (E).Also check the downrod (A) length to ensure the blades (Q) will be at least 7 ft. Ensure the blades (Q) will be at least 30 in.high.įlushmount installation is not available for this item. Note: If using the angle mount, check to ensure the ceiling angle is not steeper than 16°.Ĭlosemount-style mounting is more suitable for ceilings lower than 8 ft. A longer downrod is sometimes necessary to ensure proper blade clearance. For taller ceilings you may want to use a longer downrod (not included).Īngle-style mounting is best suited for angled or vaulted ceilings. Standard mounting is best suited for ceilings 8 ft. Turn off the circuit breakers and the wall switch to the fan supply line leads.ĭANGER: Failure to disconnect the power supply prior to installation may result in serious injury or death.Switch Housing Screw (preassembled to Fitter Plate ) Set Screw (preassembled to Motor Assembly ) Phillips-head Closemount Screw (preassembled to Motor Assembly ) Rubber Washer (preassembled to Light Kit ) Mounting Bracket Screw (preassembled to Mounting Bracket ) Motor Screw (preassembled to Motor Assembly ) Switch Housing (preassembled to Light Kit )įinial Cap (preassembled to Light Kit ) Mounting Bracket (preassembled to Canopy )Ĭanopy Cover (preassembled to Canopy )įitter Plate (preassembled to Motor Assembly ) Downrod Pin (preassembled to Downrod )ĭownrod Clip (preassembled to Downrod )
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |